Vehiculeselectriques.fr

Hello , Many thanks to De Like and Marin for your informations.Change of parameters is now very easy.Protection of my LiFePo during drive works very well and "hungry eyes" shines about 123-120VDC :D But change charging parameters is not so simple.I set 2A while five minuts interval as balancing curr...

Ok.Problem was in fuse bad cocnact :oops: But I still do not drive my car.After ten meters engine burned.Too much smoke and the end :? Ok.Problem était en fusion mauvais cocnact: oops: Mais je ne conduis toujours pas ma voiture. Après une dizaine de mètres, le moteur a brûlé. Trop de fumée et la fin:?

Thanks for answer.I did it, but I did not find problem.Sorry, I did not say all of information.First time after spare part change, all of the dash board lights blinked one time for a second.Now when I switch ignition to on, only "econometer" moves and then it fall back to left side and no dash board...

Thank you.I changed this part and good changes came.Now charger works, but car does not start to drive.Dashboard stays dead.Only pumps works.Before was electric failure light illuminated and failure was written in Lexia list.Now Lexia says "no failure" and failure light is off.Does exist some way ho...

Hello everybody. I replaced my Sagembox due to charger failure.I replaced engine, becouse it was short circuited by carbon dust.But my car still does not ride :( Lexia says "Fonction hacheur de traction".I can translate it, but i do not know where I should to looking for problem.Can anybody help me ...

solutionR92 :
Bonjour.
Je cherche votre réaction. Je vais essayer de trouver You tube video où quelqu'un programme la limitation de la vitesse de retrait. Malheureusement c'est l'allemand et la mauvaise qualité. Mais cela ne semble pas être un problème avec Diagvel.

Merci Citro. J'ai deux unités Sagem maintenant. Je suis prêt à essayer :-) 1.Changez la capacité Ah dans l'unité. 2. Changez la tension de charge maximale (pour moi 145V pour 42s) 3. Fin de la charge: prolongez la rupture de charge jusqu'à l'infini après l'atteinte de la tension. 4.Changez le mode d...

Good morning. After my problems with original charger I made my own charger which can work with DC input voltage in range 19-72V.It is nice, becouse I can charge my car directly from solar cells up to 1500W outgoing power :mrgreen: But last week I had lucky day.I bought car without aft battery box, ...

It is not what wanted to hear :mrgreen: I am going to find Sagembox to buy. :? I have not too much time to study about repair.Then I will write here and please you to help with reprograming. Thank you all for answers and your time. Ce n'est pas ce qui voulait entendre: mrgreen: je vais trouver Sagem...

Hi. Thank you for answer.When I came to my work ,I connected car to 220VAC and it started to charge.I came back after twelewe hours and car was recharged to 95% only.I didnt know that I have some problem.But then I saw cooling fluid under the car.When batteries were removed ,two of them were broken ...

Bonjour à tous. Ma batterie Nicad devrait tomber en panne. Quelqu'un a fait une mauvaise installation des tuyaux. Deux articles ont explosé pour un peu d’eau. J’ai installé LiFePo4. je peux brancher Sagembox avec Diagvel33, mais je ne peux pas lire l’eeprom aux valeurs modifiées. Mon chargeur ne fon...